Radios › FlexRadio

Operate your FlexRadio FLEX-6600 remotely

RemoteMyShack puts your FlexRadio FLEX-6600 in your browser: operate it from your phone, tablet or laptop at yourcall.remotemyshack.com, with two-way audio, its spectrum scope and waterfall, and the controls you use at the shack. A small agent on a computer next to the radio connects to it by Ethernet; there's no VPN or port forwarding to set up.

What works with the FLEX-6600

Connects by	Ethernet
Bands	160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m, 12m, 10m, 6m
Transmit	Yes, with push-to-talk from your device
Spectrum scope	Yes: the radio's own scope and waterfall, streamed to your screen (more)
Remote power-on	No (which radios can)
Tested	Yes: we've operated it ourselves

Tested. Connects as its own SmartSDR client, alongside SmartSDR. No network power switch.

What you can do from the console

Tune, change band, mode, filter and DATA mode, and read the S-meter from your phone or laptop.
Hear the radio, with two-way audio on transceivers: hold to talk, with automatic unkey if your connection drops.
Adjust RF gain, preamp, attenuator, AGC, noise blanker and noise reduction where the radio has them; the radio's own speaker is turned down while the agent is connected. On a FlexRadio the RF gain slider sets SmartSDR's AGC threshold; on a Hermes Lite 2 it sets the receive gain (LNA).
Send CW from the console with the radio's keyer (the agent keys a Hermes Lite 2 itself), and RTTY as audio.
Every transmission is recorded in your transmit log.

Setting it up

Install the agent on a Mac, Windows or Linux computer, or a Raspberry Pi, next to the radio, link it to your account, and open yourcall.remotemyshack.com. These articles walk you through it:

Other FlexRadio radios

AURORA-510 · AURORA-510M · AURORA-520 · AURORA-520M · FLEX-6400 · FLEX-6400M · FLEX-6600M · FLEX-6700 · FLEX-8400 · FLEX-8400M · FLEX-8600 · FLEX-8600M

All supported radios · Compare them in one table

Start your free 14-day trial

No credit card to start. Cancel any time.