Radios › Kenwood

Operate your Kenwood TS-890S remotely

RemoteMyShack puts your Kenwood TS-890S in your browser: operate it from your phone, tablet or laptop at yourcall.remotemyshack.com, with two-way audio and the controls you use at the shack. A small agent on a computer next to the radio connects to it by Ethernet or USB; there's no VPN or port forwarding to set up.

Beta: support for Kenwood radios is built from the maker's documentation, but we haven't run it against one yet. Tell us how it goes.

What works with the TS-890S

Connects byEthernet or USB
Bands160m, 80m, 60m, 40m, 30m, 20m, 17m, 15m, 12m, 10m, 6m
TransmitYes, with push-to-talk from your device
Spectrum scopeNot supported for this radio
Remote power-onYes: it stays reachable on your network while off, so you can switch it on from anywhere
TestedNot yet (beta)

Control over the network (KNS, administrator sign-in) or USB; audio from its USB port. Power-on over the network. The band scope isn't shown yet.

What you can do from the console

Setting it up

Install the agent on a Mac, Windows or Linux computer, or a Raspberry Pi, next to the radio, link it to your account, and open yourcall.remotemyshack.com. These articles walk you through it:

Other Kenwood radios

TS-590S · TS-590SG · TS-990S

All supported radios · Compare them in one table

Start your free 14-day trial

No credit card to start. Cancel any time.